one twisted ring from one twisted guy

here's one for you all to play with...make a finger sz crv and measure it...extrude a 4mm sguare the length of the crv and fillet the edges...turn on history and flow to the finger crv...now twist the extruded square infinate on..then cage edit the twisted square to get a wider shape on the top of ring....then wire cut 1/2 (the lower half) of the twisted extruded square.... history will do the rest....scale down to the size you need......then send the stl to the mill ...or your printer!...have fun!

▶ Reply to This

Replies to This Discussion

Permalink Reply by pat schmidt on June 10, 2012 at 9:53pm

try this one!

▶ Reply

Permalink Reply by khayreyah amani wahaab on June 11, 2012 at 3:28am

ah i see. have now fixed it. so annoying I would not have thought to cap the ends!

ta-da!

▶ Reply

Permalink Reply by khayreyah amani wahaab on June 11, 2012 at 3:29am

ta-da again!

▶ Reply

Permalink Reply by pat schmidt on June 11, 2012 at 4:18am

here's a variation from your design ...see file

▶ Reply

Permalink Reply by pat schmidt on June 11, 2012 at 4:32am

here's your file and what I did to your design I like this one! if you could have it grown it would be pretty fluid design something smooth and different...and no stones to drive up the cost! you might have to save the file and choose to open in rhino 4 I think it got saved as a rhino 5 file

Attachments: