tanca caixó 3

  • Currently 0/5 stars.

Views: 185


You need to be a member of RhinoGold to add comments!

Join RhinoGold

Comment by pat schmidt on June 3, 2012 at 8:02am

or you can solder the hinge on ...either way...

Comment by pat schmidt on June 3, 2012 at 7:45am

yes ......

Comment by pat schmidt on May 19, 2012 at 11:57pm

not saying it can't be milled but..... hey here's the tutorial on making a hand made clasp and the finished one I made I made it in silver and gold plated it a long time ago!

Comment by pat schmidt on May 19, 2012 at 9:16pm

yes I have made them before including the hinge partby hand and on the mill.... I'll look up my file and send some pictures your way I also have a great tut on making a locket by hand...these are all exercises I did to add to my porfolio years ago.... and I do mean years ago before there even was a mill on the market! 

 found some old pictures..the tab on the top was a support I didn't cut off before taking the picture 

Comment by pat schmidt on May 19, 2012 at 8:56pm

I think it would be faster to buy a box clasp unless you needed it a 'special' size..a good exercise is to hand make it!..... I have a good tutorial for hand fabricating a box clasp I'll try and post the instructions ...you could not mill this....

RhinoGold, 3D jewelry design software | Time to adapt to new technologies | Don't get left behind & Happy Designing



Top-5 Reasons to Update

Hello all,

After receiving your emails (that we highly appreciated) about the benefits of updating to RhinoGold 4.0 we have decided to create a specific website listing the TOP-5 Reasons to Update your older version of RhinoGold or basic Rhino to RhinoGold 4.0!

There are many new features and improvements in RhinoGold 4 but these are the top 5!



Created by Xavier Rofes Oct 29, 2013 at 5:30pm. Last updated by Xavier Rofes Dec 2, 2013.

© 2014   Created by Rafael del Molino.

Badges  |  Report an Issue  |  Terms of Service